Kitchens Tips

Worktop Cutting from Marble Slabs company.

The cutout for the sink must be clean and fit to be produced – only then it sits perfectly in the worktop. Prerequisite for a good result is accurate measurements.

.

Each sink is a built-in map on which the relevant dimensions for the cut in the worktop noted. It can be a sketch, or what the course work easier – a mounting template on a scale of 1:1. The template is easily set up and aligned, then the outlines touched. For an installation diagram is carefully measured and then compared with the felling touched.
Initially started with the baseline. It is located forward and has, depending on the sink in a minimum distance to Inside door edge.

.

This baseline is the foundation for pages and wall lines, the basis of its right angles with the transfer. Very important for later editing: what we now see is the outer edge of the cut sinks – they must also be visible after the cut to stay!
Thus, with the Jigsaw later better the tight curves durchsägen can drill it with the 10 – or 12-mm wood drill all four vertices in the turn of holes. Is then covered with the cut line, so that the tape from the outside of her just over the cut line. A protection for the base plate of the jigsaw to cut the inside you do not, anyway he is no longer needed.

.

Now the jig in one of the Corner holes used and the inner part cut out. It is advisable to cut to be introduced so that it due to its own weight does not break out prematurely.
If necessary, the cut surfaces are now even with the wood file smoothed the cut edge of the coating should in any case with an iron file (fine chop) broken (slightly angeschrägt) are. Could too easily when the coating otherwise fit the sink or tearing off. Later between running against moisture sealing protects the cutting edge with epoxy resin or wax.